Tension wire holder - SH 500

Tension wire holder made of PA-GF for high loads (supplied without screw)

Your session has expired, please log in again.

Material

Standard Colours

moss green RAL 6005

black RAL 9005

traffic grey A RAL 7042

Assembly information

The holding holes Ø8-8.1 mm can be recut for upgrading to SH 500 with special thread M9x1.
In this case, only custom-made screws with a large flat head and constriction in the shaft for the tension wire can be used - sensible thread: M9x1.

Close all ×

Configure your article. Enter multiple parameters to get the best result.

An error occurred! Please contact our support for help.

Reset filter

Accessories for inclined support caps

Eyelet caps made of polyethylene

Tension wire holder made of PA-GF with stainless steel hook nail